With the discussion here about AutoZoom, I decided to try AutoTaxi+ again, to see what I might be missing.
I kinda like AutoTaxi+, but I disable it because it keeps "falsing" on me. Here's the scenario:
I'm at my home airport. (So I know my way around.) When I start up iFly, it jumps to the Airport Diagram.
That's fine, but even after I dismiss it and go back to the map while taxiing (perhaps to mentally review my initial heading/TCA floors/NEXRAD, etc.) AutoTaxi+ keeps popping back up. (IIRC, same I think after I'm done with my run-up and moving up to the Hold line. It sees movement and goes to the Diagram.) Once I've dismissed the Diagram, I would like it to stay dismissed until iFly sees that I've taken off until my next landing. (Perhaps it waits both airspeed and 400 feet before it auto-reenables?)
That's my biggest problem with it.
Similarly, if I recall correctly (and I might not) - I had it enabled while practicing Instrument Approaches once. I seem to recall that it went to the Airport Diagram while I was on the Missed. (I don't recall for sure - will try it in a few days when I shoot some approaches.) Naturally I don't want it changing to the Airport Diagram until I am firmly on the ground and stopped.
I haven't tried T'N'G's with AutoTaxi+ on. Does it switch then? If so, perhaps a time delay of 20 seconds where GPS GS is less than 10 knots? (Although I don't need to look at iFly while I'm doing T'N'G's per se, I like it to stay in the map mode so that I can see traffic via Stratux.)