iFly GPS Forum

Just downloaded update and new features are great. Except on sketch, when I first load sketch and choose the type of sketch, there doesn’t seem to be a way to switch sketch modes after that. There are 2 different exit buttons but neither gets back to that page. So once I choose map or blank or whatever, I can’t figure out how to change out of that sketch mode. I can go back to the map, and then I hit sketch again and it goes straight to the previously selected mode. Am I missing something or is this a glitch?

Just to answer your question, no it's not a glitch.  It was designed that way.  The primary reason was in the case where an IFR pilot used the CRAFT Sketch, departed into the clouds, and wanted a quick look at the CRAFT Sketch again to verify the information, then get right back to the map page, or whatever nav screen they already had up.  If you notice, there are two Exit buttons, one of which is right where you clicked to get to the Sketch mode.  That's so you can quickly switch back and forth without moving your finger.  Once you Sketch something new on that page, this button changes to (I think) Undo.