Replacing my back-up battery chord - iFly Owners Q&A

We have a new Forum! Go here to get started: https://adventurepilot.community.forum.
The new forum is easier to use and much more capable than the old, we hope you will join our community!

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.

Search

Home

Discussions

iFly Owners Q&A

Replacing my back-up battery chord

6/8/2013 12:56 PM

Tom Murrell

Joined: 2/17/2011

Posts: 170

Replacing my back-up battery chord

I have misplaced the chord that runs from my back-up battery to the iFly. Can I replace that with something off the shelf? If so, what do I need to look for?

6/10/2013 11:34 AM

Shane

Joined: 4/21/2010

Posts: 1709

Re: Replacing my back-up battery chord

Tom,

It is DC power plug with these specs... 3.5mm OD x 1.3mm ID. We do have the DC hardwire on our site for $9.00.

Shane Woodson
Vice President | Adventure Pilot LLC.

6/10/2013 12:23 PM

dogbreth

Joined: 4/11/2011

Posts: 98

Re: Replacing my back-up battery chord

Shane,

I looked at the picture and it looks like the male plug on one end and an open wire on the other end (to connect to a DC power source.... is this correct?

Do you have the female end with open wire so that I can mount the femaie in the dash and connect it to the Ifly with the battery-Ifly connector cable only when I'm using the ifly?

6/10/2013 12:38 PM

Shane

Joined: 4/21/2010

Posts: 1709

Re: Replacing my back-up battery chord

Gregg,

Correct, it is the Male end that plugs into the iFly on one end and bare wires on the other end. Unfortunately we don't have the Female end as those are typically solder to the main board. You might fine that end at a Frys or Computer shop. Just a thought. I hope this hels.

Shane Woodson
Vice President | Adventure Pilot LLC.