AI problem using Stratux - iFly General Discussions - iFly EFB

iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly General Di...iFly General Di...AI problem using Stratux AI problem using Stratux
Previous
 
Next
New Post
10/15/2018 11:16 AM
 

I am evaluating ifly GPS and so far am impressed except for one issue.  Am using Stratux with the AHRS board.  When I roll into a turn the AI correctly shows the bank angle but if I hold the turn the AI returns to level in a few seconds.  On the ground it holds the bank angle as it should.  I have the latest Sratux software.  Have gone through calibration a few times.  Any ideas?  Searched but did not find anything related.  

Thanks DHS

 
New Post
10/15/2018 12:36 PM
 

You need to install an AHRS module in your Stratux. They are $15 on Amazon.

 
New Post
10/15/2018 2:34 PM
 
Tim Taylor wrote:

You need to install an AHRS module in your Stratux. They are $15 on Amazon.

 

---------------------

Concur - I have installed it and mine holds the bank thorugh the entire turn.  Good advice.

Mike N714AJ

 

 
New Post
10/16/2018 3:55 PM
 

Second sentence...Am using Stratux with the AHRS board.

 
New Post
10/16/2018 3:59 PM
 
DHS wrote:

Second sentence...Am using Stratux with the AHRS board.


In that case, I have no idea. Sorry I can't help you.
 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly General Di...iFly General Di...AI problem using Stratux AI problem using Stratux