iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly General Di...iFly General Di...Raspberry Pi ADSB-INRaspberry Pi ADSB-IN
Previous
 
Next
New Post
9/8/2015 3:50 PM
 

The Rasberry PI ADS-B-In setup works with the iFly GPS App on an Apple iPad or iPhone, however the config settings do not allow for it to be used on an Android or the iFly devices. We've played around with it here in the office. It works for the iPad/iPhone, but not officially supported on the iFly devices or Android.


Shane Woodson
Vice President | Adventure Pilot LLC.
 
New Post
9/9/2015 11:34 AM
 

Jeff, I used the parts listed in the original article - http://www.amazon.com/dp/B00P2UOU72/ref=cm_sw_su_dp

I'm going to mount a 978 antenna on the belly to feed this.

I found updated S/W on Github last night, and now the iFly 720 and the Android phone both see the Ras-Pi radio. I'll test it again in the air later today or tomorrow.

https://github.com/cyoung/stratux/releases

 
New Post
9/9/2015 12:13 PM
 
I came accross this, maybe it will help you

http://sonicgoose.com/mode-s-and-ads-b-on-a-raspberry-pi/

Ciao
 
New Post
9/11/2015 9:47 AM
 
Shane wrote:

The Rasberry PI ADS-B-In setup works with the iFly GPS App on an Apple iPad or iPhone, however the config settings do not allow for it to be used on an Android or the iFly devices. We've played around with it here in the office. It works for the iPad/iPhone, but not officially supported on the iFly devices or Android.

As someone who's been working on this project since the beginning, I can assure you that is works great with ifly on Android. In fact, that's how I use it primarily.

 
New Post
9/11/2015 1:07 PM
 

When I upgraded to the v0.2r1 release, it worked with all three platforms. I see that v0.3b1 is out, I'll try that next. It just keeps getting better!

https://github.com/cyoung/stratux/releases

 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly General Di...iFly General Di...Raspberry Pi ADSB-INRaspberry Pi ADSB-IN