iFly GPS Forum

Hello iFly crew, I just updated my iFly 700 and I pulled up the navigation page to play with a route to Oshkosh. I entered the identifiers for the airports where I plan to stop and I then tried to rubber band the route to the town of Ripon. However, when I touched the screen, the sectional starting jumping around frantically and I couldn't hook the course line. I finally got the line hooked and got the waypoint added but I've never seen the screen do anything like that before. Is it possible that my screen is going bad? Sam Washington

Sam,

I'd recommend performing a screen calibration using a toothpick or fine point stylus. Calibration can be done from the booth menus or the Screen Setting menus within the iFly Navigation software.

If it does not calibrate and simply moves the touch point in a loop, then I would suggest giving our support team a call so we can get the unit in for extensive testing. I hope this helps.

---

Shane Woodson
Vice President | Adventure Pilot LLC.

The screen calibration is independent of the iFly software version. It's more likely that the screen on your 700 is going bad. As Shane mentioned above, it's probably worth a call to the good folks at iFly support...there are a couple of tricks they can suggest that may help you get some more life out of your current screen, and if those don't work, they can talk to you about options for repair or replacement.