iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly Wish-ListiFly Wish-ListiFly calculate and report crosswind component?iFly calculate and report crosswind component?
Previous
 
Next
New Post
5/8/2018 11:16 PM
 

I can see some difficulty, as you point out, for multi-runway airports particularly. Not insurmountable though. Could just broadcast for the one or two most used, and simply not include a component report anytime there wasn't a preferred runway.per the AWAS. And never when "wind calm" is in the report.

Our one runway AWOS typically reports "conditions favor runway three zero" or "Pilot's discretion".   Anytime "conditions favor runway three zero" is reported it would report "cross-wind-component for runway three zero is XX knots from the left" or right as case may be. Not do it under other conditions.

Getting the crosswind component simply and clearly audio stated SOMEtimes would be better than what we have now..... which is that even in the clearest and easy to calculate and report case it is NEVER broadcast. Leaving us to make seat of pants guesses.

 

 
New Post
5/9/2018 12:18 AM
 

Way back when--we all carried a whiz wheel, better known as an E6B. Then electronics came along and pilots forgot how to do the simple things. Progress???

Dick Welsh

 
New Post
5/11/2018 7:17 AM
 

Could be we (me) is confusing terms, but the airplane/aircraft does matter....

Contrary to what some pilots may think, an aircraft's maximum demonstrated crosswind component is only an operating limitation if the aircraft's manufacturer says so. It's not a limitation imposed by FAA regulations. During the type certification process, the FAA requires the manufacturer to demonstrate that its airplane can be controlled in 90-degree crosswinds up to 20% of Vso. The demonstration is performed by a test pilot who's not supposed to use exceptional skill or alertness. The FAA doesn't require that a manufacturer set limitations based on the demonstration, or even publish guidelines for gusty crosswinds that may briefly exceed the maximum demonstrated crosswind component. Pilots need to know what their airplane will or won't do in crosswinds unites pilots of light-sport aircraft, jet airliners and everything in between.

Great discussion, thanks!

Mike, N714AJ

 
New Post
5/11/2018 10:29 AM
 

Of course.  As licensed pilots, I think we all know about demonstrated crosswind component and, hopefully, we all know what that is for the airplanes we fly and what it means.  However, for iFly to calculate crosswind component, all it would need is wind direction and velocity and runway heading.  It would be the same for every airplane.

 
New Post
6/4/2018 8:52 AM
 

Nice to know Xwind Component. My Dynon D10 gives me that. Really nice to have. Especially when upstairs in seeing wind effects. 

It is interesting to see the winds change as I travel and it is a great way to find best cruise altitude.

When I and my wingmen are on a long X country and bucking headwinds, I will climb or descend to find better winds.

You really can't depend on what you see in the winds aloft view on IFLY. They are general...not local.

 

 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly Wish-ListiFly Wish-ListiFly calculate and report crosswind component?iFly calculate and report crosswind component?